Owner's Manual

USA-8
USA
USA-7
Programming radio channel settings
Programming transmitter/channel
Prerequisite: The receiver must be installed.
1. With pre-installed electric receivers,the fuse must be
disconnected and reconnected after a few seconds.The receiver
will remain in programming mode for approximately 5 minutes.
2. Position yourself in front of the roller shutter/awning/blind with
the remote control in your hand.
3. Open the front cover of the device and press the transmitter pro-
gramming button P briefly. The shutter/awning/blind will start to
move up and down.This will happen for approximately 2 minutes.
4. To define the keyboard layout,press the UP button on the trans-
mitter as soon as the shutter/awning/blind begins to move
upwards (after approx. 1 second).The shutter/awning/blind will
come to a halt briefly.
As soon as the shutter/awning/blind begins to move again,press
the DOWN button on the handheld transmitter.
The shutter/awning/blind will come to a stop.
The transmitter or this channel has been successfully programmed.
Programming additional transmitters
To programme additional transmitters in one receiver,please proceed
as follows:
1. Press the UP,DOWN and programming button P on a transmitter
that has already been programmed in the receiver until the LED
goes out.
2. To define the keyboard layout,press the UP button on the handheld
transmitter as soon as the shutter/awning/blind begins to move
upwards (after approx.1 second).
The shutter/awning/blind will come to a halt briefly.
As soon as the shutter/awning/blind begins to move again,press
the DOWN button on the handheld transmitter.
The shutter/awning/blind will come to a stop.
The transmitter or this channel has been successfully programmed.
Explanation of functions
Manual/Automatic sliding switch
The sliding switch is used to switch the receivers into either
manual or automatic mode.
When the sliding switch is set to automatic mode, the
receivers will respond to every signal transmitted,whereas in
manual mode they will only respond to UP,STOP and DOWN
control commands,as well as to wind alarm signals.
Transmission control light
The transmission control light is illuminated when a radio
signal is being transmitted.
The transmission control light will flash during transmission if
battery power is low.
The transmission power or radio operating range will decrease
as battery power decreases.If the transmission control light
does not light up when the buttons are pressed, the batteries
must be replaced.
Group control
Group control refers to the operation of one or more receivers
at the same time.The group selected is controlled via a control
command.
The LumeroTel-915 operates the chosen group via a radio
channel.
Note: The inlay card beneath the transparent cover can be
used to make a note of the groups which have been
programmed.