Owner's Manual

USA-9 USA-10
USA
Intermediate position for roller
shutter/awning/venetian blind
Programming Pos B
Prerequisite: The transmitter has been programmed and the
end limit positions have been set.The curtain/
canopy/blind is in the upper end limit position.
1. Adjust the curtain/canopy/blind into the desired position
using the DOWN button.
Note: Keep the DOWN button pressed until the desired posi-
tion is reached.
2. When the curtain/canopy/blind has reached the desired
position, press the STOP button in addition.
The curtain/canopy/blind will come to a stop.The
intermediate position has been successfully programmed.
Programming Pos V
Prerequisite: The transmitter has been programmed and the
end limit positions have been set.The curtain/
canopy/blind is in the lower end limit position.
1. Move the curtain/canopy/blind in the UP direction using
the handheld transmitter until the ventilation slits are open
or the reverse position has been reached.
Note: Keep the UP button pressed until the desired position
is reached.
2. When the curtain/canopy/blind has reached the desired
position, press the STOP button in addition.
The curtain/canopy/blind will come to a stop.The venti-
lation/reverse position has been successfully programmed.
Roller shutter Awning Venetian blind
Pos B
Intermediate Intermediate Intermediate
position position position
Pos V Ventilation position Canopy tension Reverse position
Programming radio channel settings
Note: If more than one receiver is connected to the same supply
lead, all of these will be in programming mode
simultaneously.The shutters/awnings/blinds will begin to
move up and down “at random”.The longer you take to
carry out the programming, the larger the offset will be.
Individual channels can now be assigned to the given
receiver.
To stop the brief up and down movements,press the
STOP button on one of the pre-programmed handheld
transmitters briefly.
Channel assignment/modification can now be carried out
without you having to disconnect individual receivers.
If the shutter/awning/blind moves in the wrong direction,
the transmitter must be deleted and re-programmed.