Owner's Manual

USA-12
USA
USA-11
Operating voltage 3 V DC
Battery requirements 2 x LR 03 (AAA)
System of protection IP 20
Permissible ambient temperature –10 to +55 °C
Operating frequency 915,3 MHz
Dimensions in mm L 121 x W 43 x H 23
Deleting individual transmitters
Disconnect the fuse – and reconnect after a few seconds.
1. Open the front cover on the device and press the following
buttons simultaneously:
• Programming button P
• STOP button
2. Keep these two buttons pressed until the LED goes out briefly.
Deleting all transmitters
Disconnect the fuse – and reconnect after a few seconds.
1. Open the front cover on the device and press the following
buttons simultaneously:
• Programming button P
• UP button
• STOP button
• DOWN button
2. Keep these buttons pressed until the LED flashes 3 times.
Technical data
The maximum radio operating range is 25 m indoors and 350 m
outdoors.
Deleting radio channel settings/
Technical data
Intermediate position for roller
shutter/awning/venetian blind
Adjustment to Pos B
Prerequisite: The transmitter has been programmed.
1. Press the UP button twice in quick succession.
2. The drive will adjust the curtain/canopy/blind into the stored
intermediate position.If no intermediate position is stored,the
curtain/canopy/blind is automatically adjusted into the lower
limit position.
Adjustment to Pos V (roller shutter, awning)
Prerequisite: The transmitter has been programmed.
1. Press the UP button twice in quick succession.
2. The curtain/canopy is adjusted into the stored ventilation
position. If no ventilation position is stored,the curtain/canopy
is automatically adjusted into the upper limit position.
Adjustment to Pos V (venetian blind)
Prerequisite: The transmitter has been programmed.
1. Press the UP button twice in quick succession.
2. The blind is adjusted into the stored reverse position. If no
reverse position is stored, the blind is automatically adjusted
into the lower limit position.
Deleting Pos B
1. Press the following buttons simultaneously:
• DOWN button
• STOP button
2. Keep these two buttons pressed until the LED goes out briefly.
Deleting Pos V
1. Press the following buttons simultaneously:
• UP button
• STOP button
2. Keep these two buttons pressed until the LED goes out briefly.