User's Manual Addendum

Title Safety instructions - User manual addendum
Document Number Elesa-R&D-DDEDOC-036-01en
Date 14/05/2021
Page 4
1 SCOPE
This document contains the safety instructions and mandatory by law warnings that have to be supplied with the
user manual of DD52R-E products.
2 Mandatory instructions
Safety instructions
This device has been designed and manufactured in accordance with current legislation. To keep the product in
this state, it must be assembled and used correctly, in strict compliance with the instructions contained in this
instruction manual and with the following specific safety precautions.
This manual is intended as an indispensable supplement to the existing documentation (catalogues, data sheets
and assembly instructions).
Make sure that the user has read and understood the instruction manual and in particular this chapter "Safety
instructions".
In addition to the instruction manual, all legal regulations regarding accident prevention and environmental
protection must be observed.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.’
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates,uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
Use without respecting the specific descriptions/parameters, in combination with systems/machines/processes to
be controlled, can lead to product malfunction, which causes:
- health hazards,
- environmental hazards,
- damage to the product and to its proper functionality.
The device must not be used:
- in explosion hazard areas;
- in medical/life support areas and equipment.
Do not open the equipment and do not apply any modifications!
Modification of the equipment could adversely affect the reliability of the device and could lead to hazards! Do not
attempt any repairs.
Always return any defective equipment to the manufacturer!
Any breach of the integrity of the device as delivered will invalidate the warranty.
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate
the equipment
Configuration / Commissioning
In the event of abnormal behaviour (including change of operating conditions), the device must be shut down
immediately. Installation and commissioning must only be carried out by adequately trained and authorised
personnel. After correct assembly and commissioning, the device is ready for operation.