User's Manual

2.1 OPERATING ENVIRONMENT

You can install the apparatus in a standard component rack or on a suitable surface such as a bench or desk.

In any case, the area should be as clean and well-ventilated as possible. Do not locate the transmitter directly

above a hot piece of equipment. The upper lid can be dismounted to allow an easy internal access. The

equipment is designed with a modular design, that is each circuit is realized inside different modules or boards.

All interconnections between modules are made by means of connectable cables which allow an easy and

quick maintenance of demaged modules.

2.2 FIRST INSTALLATION

1. Connect Antenna cable

2. Connect AC POWER cord

3. Select step and frequency with display interface

4. Move power slowly up till nominal power and check the Reflected Power to be low. If Reflected Power

increase check the RF Output connections

AUDIO INPUT

(LEFT only with OPT023)

AC POWER

To ANTENN

GND

Only with OPT023