User's Manual

67
- Description of the adjustment points
 Disconnect the input terminal of the module. Connect the dummy load to the output terminal.
 Turn R4 and R24 completely clockwise (so to interdict the transistors).
 Disconnect the passing capacitor from TP3 Gate.
 Turn the R4 trimmer counterclockwise until the display of the Amperometer shows an absorption of
300mA. Stop powering the module.
 Connect a Tester as Amperometer (10A cc scale) on the power supply line (in place of the L8 coil) and
power the module.
 Turn the R24 trimmer counterclockwise until the display of the Amperometer shows an absorption of
80mA. Stop powering the module.
 Reconnect the passing capacitor to TP3 Gate.
COMPONENT DESCRIPTION
R4, R24
Adjust polarisation