User Manual

36
2.1 OPERATING ENVIRONMENT
You can install the apparatus in a standard component rack or on a suitable surface such as a bench or desk.
In any case, the area should be as clean and well-ventilated as possible. Do not locate the transmitter directly
above a hot piece of equipment.
2.2 FIRST INSTALLATION
Correct installation of the equipment is important for maximum performance and reliability. Antenna and earth
connections must be installed with the greatest care. No equipment adjustment is needed, because the unit is
completely adjusted by our technical staff. This is the installation procedure:
1. Connect Antenna cable.
2. Connect AC POWER cord.
3. Connect the ASI/SMPTE Inputs you want to use depending on available auxiliary inputs (see the table in
Input Management paragraph).
4. Move power slowly up till nominal power and check the Reflected Power to be low. If the Reflected
Power increases check the RF Output connections.
LINE SOCKET
RS485
TELEMEASURES
10MHz
IN
RF OUT
10MHz
OUT
SMPTE1
ASI2
ASI1
SMPTE2
AC POWER
To Bandpass Filter
or High Power Amplifier
ASI/SMPTE INPUT