User Manual

49
- VCT submenu
VCT is the acronym for Virtual Channel Table.
MCN Update (Enabled, Disabled)
If this parameter shows Enabled, the Major Channel Number (MCN) field of the VCT is
updated with the value below. If this parameter is disabled, the MCN field is untouched by
the modulator.
Freq. Update (Enabled, Disabled)
If this parameter shows Enabled, the frequency field of the VCT is updated with the value
below. If this parameter is disabled, the MCN field is untouched by the modulator.
MCN (0-99)
This parameter is the new value for Major Channel Number (MCN) field in the VCT,
updated by the modulator if MCN Update parameter above is Enabled.
Freq (0-999999999Hz)
This parameter is the new value for frequency field in the VCT, updated by the modulator
if Freq. Update parameter above is Enabled.
Click on knob to enter a new value for the frequency. The first digit is reversed shown to
indicate that it is possible to change it rotating the know. Click on knob to pass to the next
digit up to the last. Clicking on the last digit, the usual confirmation question will be shown.