User Manual

Spectrum (Normal, Inverted)

This parameter enables or disables the spectrum inversion.

RF Mute (Auto, ON)

If you set this parameter to ON, the output is muted. If Auto is set, the output can be muted

depending on some conditions. In this case, the current mute status is shown in parenthesis.

Mute on In. Err (ON, OFF)

If this parameter is set to ON, the output will be automatically muted whenever an error on

ASI inputs occurs (for example if the inputs are absent). If it is set to OFF, errors on ASI

inputs don’t affect the output muting.

Mute Type (Fast, Slow)

This parameter sets the mute type. If Fast is set, the mute will be direct (abrupt muting). If

Slow is set, the mute will be progressive.

- OUTPUT submenu

- PRECORRECTION submenu

Linear Precorrection (ON, OFF)

With this parameter it is possible to change the linear precorrection behaviour of the modulator.

If it is set to OFF, the linear precorrection is disabled. If it is set to Null, the linear precorrection

is enabled, but a “null curve” is used. Other linear precorrection curves, up to 2, each characterized

by a different name, could be stored inside the controller. In this case, the user can select one of

them. See the Linear Precorrection paragraph for more information.

Tilt (-1.0÷1.0dB by 0.1dB step)

This parameter is used to add a tilt precorrection on the spectrum. See the Output Signal

paragraph for more information.

Non lin (ON, OFF)

With this parameter it is possible to change the non-linear precorrection behaviour of the modulator. If

it is set to OFF, the non-linear precorrection is disabled. If it is set to Null, the non-linear precorrection

is enabled, but a “null curve” is used. Other non-linear precorrection curves, up to 10, each characterized

by a different name, could be stored inside the controller. In this case, the user can select one of them.

See the Non Linear Precorrection paragraph for more information.