User Manual

62
- DISPLAY submenu
Backlight (0÷100%)
The graphical LCD has a white-LED backlight. Its intensity can be changed by software
using this parameter. Differently from usual parameters, the modification immediately takes
place when the user rotates the knob. When you reach the desired intensity level, click on
the knob and reply “Yes” to the confirmation question to accept the new value. If you reply
“No”, the value set before entering the parameter is restored. If the user doesn’t use the
knob for more than 1 minute, the display backlight is automatically switched off. Click or
move the knob to switch the LCD backlight on. The knob action (clicking or moving) that
switches on the backlight isn’t used for menu and parameters browsing/settings.
Contrast (0÷100%)
As well as the backlight, the display contrast can be changed by software using this
parameter. Differently from usual parameters, the modification immediately takes place
when the user rotates the knob. When you reach the desired contrast level, click on the
knob and reply “Yes” to the confirmation question to accept the new value. If you reply
“No”, the value set before entering the parameter is restored.
- CLOCK submenu
Date (dd/mm/yy)
With this parameter it is possible to see and change the date stored in the control board. It
is shown in the dd/mm/yy format (dd=day of the month, mm=month, yy=year).
Be sure to set the correct date because it will be stored with log events.
Time (hh:mm:ss)
With this parameter it is possible to see and change the current time stored in the control
board. It is shown in the hh:mm:ss format (hh=hours, mm=minutes, ss=seconds).
Be sure to set the correct time because it will be stored with log events.