User's Manual Part 1

22
settings;
- the parameters which can be continuously set are represented by a bar showing the indication of the current
value (light) and of the one set at the factory (dark);
- Actions (e.g. "Clear History") are always followed by the ->|<- symbol. By selecting this voice and cofnirming,
the action will be executed.
l Pressing the knob while in any of the menus turns on a blinking cursor which can be used to select any
parameter simply by turning the control. Then the knob can be pressed again to open the window allowing to
change the selected parameter. In this window the control allows to choose the value, which has then to be
confirmed when requested.
2.2 MENU DESCRIPTION
- Multistandard Audio Mono Section
EXIT
Clicking on the knob, after selecting this voice, goes back to the default menù.
Overload
Shows whether there is (Prst), there isnt (Abst) or there was (Trig) an overload of the audio signal. In
Absent and Triggered case, the label blinks.
Reset Trig
Clicking on the knob, after selecting this voice, delete the triggered indication from the overload.
Zin
Clicking on then knob, after selecting this voice, goes into the menu that allows to change
the impedance of the audio signal input connectors from 600Ohm to 10kOhm and back.
Rotate the knob to select the desired value and click on it.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.