User's Manual Part 1

25
- Multistandard Audio Stereo Section (Option)
The last menu is showed as in stereo or mono mode settings. If the mode is set for a dual sound audio
modulation the last menu become the one below, because you can select to adjust the audio level to different
values.
EXIT
Clicking on the knob, after selecting this voice, goes back to the default menu.
OverloadL and OveroadR
Shows whether there is (Prst), there isn't (Abst) or there was (Trig) an overload of the audio left and right
signal. In Absent and Triggered case, the label blinks.
Reset Trig
Clicking on the knob, after selecting this voice, delete the triggered indication from the overload.
Zin
Clicking on then knob, after selecting this voice, goes into the menu that allows to change
the impedance of the audio signal input connectors from 600W to 10kW and back.
Rotate the knob to select the desired value and click on it.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.