User's Manual Part 1

26
Limiter
Clicking on then knob, after selecting this voice, goes into the menu that allows to change
the Enables or Disables the limitation circuit. Rotate the knob to select the desired value
and click on it.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.
IF1
Clicking on then knob, after selecting this voice, goes into the menu that allows to toggles
between on and off of the IF1. Rotate the knob to select the desired value and click on
it.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.
IF2
Clicking on then knob, after selecting this voice, goes into the menu that allows to toggles
between on and off of the IF2. Rotate the knob to select the desired value and click on
it.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.
Source
Clicking on then knob, after selecting this voice, goes into the menu that allows to choose
whether to sample the input signal from the front or rear panel. Rotate the knob to select
the desired value and click on it.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.