User's Manual Part 1

Mode

Clicking on then knob, after selecting this voice, goes into the menu that allows to choose

the operating mode between mono, stereo or dual sound. Rotate the knob to select the

desired value and click on it.

Answer to the confirming question, selecting between accept or not. The answer starts

always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the

knob.

Emph.

Clicking on then knob, after selecting this voice, goes into the menu that allows to toggles

between presence and absence of the emphasis. Rotate the knob to select the desired

value and click on it.

Answer to the confirming question, selecting between accept or not. The answer starts

always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the

knob.

SC1

Shows the PLL lock or unlock of the subcarrier 1. In case of unlock, the label blinks.

SC2

Shows the PLL lock or unlock of the subcarrier 2. In case of unlock, the label blinks.

SC1Dev

Shows the Deviation in kHz of the subcarrier 1.

SC2Dev

Shows the Deviation in kHz of the subcarrier 2.

IF1 Level

Clicking on then knob, after selecting this voice, goes into the menu that allows to sets the

IF1 level. Rotate the knob to select the desired value and click on it. The actual level is

represented by the empty arrow, the full arrow represent the value of the factory setting

of this level. This 'factory default marker' can help you to set-up the exciter to a good

value, without ant instrumentation.