User's Manual Part 1

32
- Multistandard Local Oscillator Section with Line Offset
EXIT
Clicking on the knob, after selecting this voice, goes back to the default menu.
Channel
Clicking on then knob, after selecting this voice, goes into the menu that allows to select
the transmission channel for the selected standard. Rotate the knob to select the desired
value and click on it.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.
Line offset
Clicking on then knob, after selecting this voice, goes into the menu that allows to set the
line offset in either positive (P) or negative(M) steps from 15M to 15P. Rotate the knob
to select the desired value and click on it.
Offset[Hz] = LineOffset[Step]*(LineFrequency[Hz]/12)
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.
VCO
Shows the oscillator PLL lock or unlock. In case of unlock, the label blinks.