User's Manual Part 1

33
Output
Clicking on then knob, after selecting this voice, goes into the menu that allows to toggle
the oscillator output. Rotate the knob to select the desired value and click on it.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.
Ref
Clicking on then knob, after selecting this voice, goes into the menu that allows to select
whether the reference is internal or external . Rotate the knob to select the desired value
and click on it.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.
L.O. Tune
Clicking on then knob, after selecting this voice, goes into the menu that allows to fine
adjust the frequency of Local Oscillator, usefull only in case of absence of an external
reference. Rotate the knob to select the desired value and click on it. The actual level is
represented by the empty arrow, the full arrow represent the value of the factory setting
of this level. This 'factory default marker' can help you to set-up the exciter to a good value, without ant
instrumentation.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.