User's Manual Part 1

36
- Multistandard Channel Filter Section
EXIT
Clicking on the knob, after selecting this voice, goes back to the default menu.
PwrCtrlMode
Clicking on then knob, after selecting this voice, goes into the menu that allows to switch
between the manual and automatic (AGC) power control mode. Rotate the knob to
select the desired value and click on it. The Auto or Manual selection will be always
displayed on the top bar.
ATTENTION: for safety operation is better to set 0% to the power level that in not selected.
For example is AUTO power control mode is selected, is better to set 0% to the Power Level in manual
mode. In this way, after a change, the power will start from 0W.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.
Auto Pwr level
Clicking on then knob, after selecting this voice, goes into the menu that allows to select
the operating level of the power in case of automatic power control mode selected.
Rotate the knob to select the desired value and click on it.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.
Manual Pwr level
Clicking on then knob, after selecting this voice, goes into the menu that allows to select
the operating level of the power in case of manual power control mode selected. Rotate
the knob to select the desired value and click on it.