User's Manual Part 1

39
- Controller Module Section
EXIT
Clicking on the knob, after selecting this voice, goes back to the default menu.
Hist View
Clicking on then knob, after selecting this voice, goes into the menu that allows to show
all the events stored into the non volatile memory of the VEGA. In the title bar is showed
the current event number and the total events actually stored into the log. To move inside
the log simply rotate the knob. Click the knob to exit from the history view.
Hist Clear
Clicking on then knob, after selecting this voice, goes into the menu that allows to clear
all the events stored in the history log.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.
Control
Clicking on then knob, after selecting this voice, goes into the menu that allows totoggle
the local or remote control mode. Rotate the knob to select the desired value and click
on it.
When in remote mode either the telemeasuring connector or the serial port can be used to control the exciter.
Telemeasuring connector and serial port can be always used to monitor the exciter.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.
Contrast
Clicking on then knob, after selecting this voice, goes into the menu that allows to adjust
the contrast settings of the display. Rotate the knob to select the desired value and click
on it.