User's Manual Part 1

45
- BUS Structure Section
EXIT
Clicking on the knob, after selecting this voice, goes back to the default menu.
Power
Clicking on then knob, after selecting this voice, goes into the menu that allows to turns
on or off the power supply of the whole BUS. Rotate the knob to select the desired value
and click on it.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.
Polling
Clicking on then knob, after selecting this voice, goes into the menu that allows to turns
on or off the BUS polling feature. Rotate the knob to select the desired value and click
on it.
If 'BUS polling' enabled the display board will poll continuously all the board to obtain
the data values. If 'BUS polling' disabled the boards will inform by using an interrupt line
that a value has changed on them.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.
+Vdigital
Shows the measure of the +5V power supply voltage of the bus. In case of abnormal value, the label blinks.
+/-Vanalog
Shows the measure of the +/-15V power supply voltage of the bus. In case of abnormal value, the label
blinks.