User's Manual Part 1

46
- External Reference Section
EXIT
Clicking on the knob, after selecting this voice, goes back to the default menu.
IF link
Clicking on then knob, after selecting this voice, goes into the menu that allows to choose
whether the IF connection is internal or located on the rear panel. Rotate the knob to
select the desired value and click on it.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.
ExtReference
Shows whether the external reference is present.
ExtRef Dir
Clicking on then knob, after selecting this voice, goes into the menu that allows to set the
direction of the reference. Rotate the knob to select the desired value and click on it.
Answer to the confirming question, selecting between accept or not. The answer starts
always from "Accept: NO", so to exit quickly form this menu simply click 2 times on the
knob.
ExtRef Tune
Clicking on then knob, after selecting this voice, goes into the menu that allows to fine
adjust the frequency of the external reference. Rotate the knob to select the desired value
and click on it. The actual level is represented by the empty arrow, the full arrow represent
the value of the factory setting of this level. This 'factory default marker' can help you to set-up the exciter to