User's Manual Part 1

2.1 OPERATING ENVIRONMENT

You can install the apparatus in a standard component rack or on a suitable surface such as a bench or desk.

In any case, the area should be as clean and well-ventilated as possible. Always allow for at least 2 cm of

clearance under the unit for ventilation. If you set the apparatus on a flat surface, install spacers on the bottom

cover plate. If you install the apparatus in a rack, provide adequate clearance above and below. Do not locate

the apparatus directly above a hot piece of equipment.

2.2 PRELIMINARY OPERATIONS

Correct installation of the equipment is important for maximum performance and reliability. Antenna and earth

connections must be installed with the greatest care. The equipment adjustment isnt need, because the unit is

completely adjusted by our technical staff. This is the installation procedure:

1. connect the power supply cable of the exciter to the auxiliary socket on the rear panel of the amplifier;

2. connect the power supply cable of the amplifier to the electric network (230VAC). If there is the Isolator

Transformer, the amplifier is provided with cable and plug;

3. connect the exciter / antenna cables respectively to the RF IN and RF OUT on the rear panel of the

amplifier.

WARNING!!!

FOR ELECTRICAL SAFETY REASONS AND IN ORDER TO KEEP THE APPARATUS SAFE,

THE GROUND TERMINAL OF THE APPARATUS MUST BE CONNECTED TO THE EXISTING

GROUNDING SYSTEM AND NOT BY USING THE SHIELD OF THE OUTPUT COAXIAL CABLE.

Mono-Phase cabling

1 = L

2 = L

3 = N

4 = N

5 = GND