Use and Care Manual

Page 13
Mouser Advanced User Manual
Compatible Command Classes
Command Class Notes
Notication V4 (71)
The Mouser sends a Notication Report when the trap is triggered,
reset, armed, and disarmed. It primarily uses the Pest Control Notica-
tion Type, but also sends a Home Security, Motion Detected (Unknown
Location) Report when the trap is triggered and a Home Security, Event
Inactive when the trap is reset to ensure compatibility with all Z-Wave
Controllers.
Returned Value: 00 00 00 FF 13 XX 00 00
V1 Alarm Type: 00 (Unsupported)
V1 Alarm Level: 00 (Unsupported)
Reserved: 00 (Reserved)
Notication Status: FF (Unsolicited Reporting is Enabled)
Notication Type: 13 (Pest Control)
Event:
Pest Exterminated—08 (Pest Exterminated, Unknown Location)
Pest Removed—00 (State Cleared)
Trap Armed—02 (Trap Armed, Unknown Location)
Trap Unarmed—04 (Trap Re-Arm Required, Unknown Location)
Sequence/Reserved/Event Parameters Length: 00
Notication Event Parameters: 00 (No Event Parameters)
Returned Value: 00 00 00 FF 07 XX 00 00
V1 Alarm Type:t 00 (Unsupported)
V1 Alarm Level: 00 (Unsupported)
Reserved: 00 (Reserved)
Notication Status: FF (Unsolicited Reporting is Enabled)
Notication Type: 07 (Home Security)
Event:
Pest Exterminated—08 (Motion Detected, Unknown Location)
Pest Removed—00 (Event Inactive)
Sequence/Reserved/Event Parameters Length: 00
Notication Event Parameters: 00 (No Event Parameters)
Manufacturer Specic V2 (72)
Returned Value: 02 1F 03 01 01
Manufacturer ID: 02 1F
Product Type: 03
Product ID: 01 04
Wake Up V2 (84)
The wake-up interval is set in seconds, and is 43,200 seconds (12 hours)
by default. The wake-up interval can be set to any value from 300s (5
minutes) to 16,777,200s (about 190 days) in 60-second increments.
Conguration V1 (70)
See ““Conguration” Command Class Parameters” on page 14.
Table 5 - Command Classes Continued