Use and Care Manual
Water Main Shut-Off Advanced User Manual
Factory Reset & Misc. Functions
Page 8
Resetting the Water Main Shut-Off
If needed, the Water Main Shut-Off can be reset locally by following these steps.
Only do this when your Z-Wave controller is disconnected or otherwise unreach-
able. Beware that resetting your device will disconnect it from your system:
1. Press and hold the OPEN/CLOSE BUTTON for at least 10 seconds then re-
lease.
2. The Water Main Shut-Off’s memory will be erased to factory settings.
3. A flashing light indicates a successful factory reset.
Emergency Operation
The Water Main Shut-Off can be operated manually in the event of a power out-
age, loss of communication with your Z-Wave Hub, or some other emergency.
Follow these instructions to manually operate the Shut-Off:
1. Unplug the power from your device.
2. Locate the MOTOR CLUTCH on the underside of your device (Fig 3,) and pull
it outward by the keychain ring. The CONTROL ARM will disengage from the
motor and move freely.
MOTOR CLUTCH
Figure 3 - Finding the MOTOR CLUTCH
Factory Reset & Misc. Functions