24 " HIIGH-VELOCITY DRUM FAN ITEM NO : FAN-D24 120V / 60Hz, 2.5A READ & SAVE THESE INSTRUCTIONS Questions, problems, missing parts? Before returning the product, please e-mail our customer service by hicfm@outlook.
1. Read and save these instructions. Do not operate fan unless you have read these instructions. 2. Unplug the fan before moving it or performing maintenance. Do not touch the fan when your hands are wet. 3. Those who are not qualified electricians should not disassemble, repair or rebuild the fan. 4. Unplug the fan when it is not in use. 5. DO NOT unplug the fan by pulling the cable cord. Unplug by holding the plug and pulling. 6. DO NOT use the fan when there is damage to the cable cord or plug.
1. Connect the Fixing Plate with Base Bracket by 2 screws ST5*16. Screw ST5*16 Fixing Plate Base Bracket 2. Install the Square Tube with Base Bracket by 2 screws ST5*35.
3. Assembly the Wheels by inserting the Wheel Shafts into the Base Bracket. Wheel Shaft 4. Take the Split Pin through the hole of Wheel Shafts, and open it for secure the wheels location.
. Assembly the Base Bracket with two side of Drum body by fastening the Locking Knobs, Flat Washers, Serrated Washers and Rubber Pads. Rubber Pad Flat Washer Locking Knob Serrated Washer 6. Adjust the Locking Knobs to secure the drum in desired position, and tight it by turning the Locking Knobs clockwise.
0 Stop 1 Low 2 5 Medium 3 High
The manufacturer warrants this product to be free from manufacturing defects in the material and workmanship under normal use for a period of one year after the date of purchase by the original purchaser. This warranty does not cover transit damages. This warranty does not apply to damages from accident, misuse, alteration of any kind to the fan or where the connected voltage is more than above the nameplate voltage. This warranty does not apply to the finish on any portion of the product.
