Operating instructions

SW 5250A•SW 3500A•SW 1750A Operation
Operation Manual 3-5
   %!
The PROGRAM menu allows you to:
• Select a phase
• Program amplitude
• Program current limit
• Program frequency
• Program phase offset (phase offset represents a phase lead with respect to the
internal reference)
• Select a function to be output on the selected phase.
PROGRAM
MEASURE
WAVEFORM
SEQUENCE
INSTR
SYSTEM
PHASE A (or B or C)
AMPL V
CURL A
FREQ Hz
ANG Deg
FUNC
MAIN MENU OUTPUT [OFF]
θ

PROGRAM Menu Status and Information Data:
Menu Item Status and Information Line Range/Default
PHASE A [<enter> for next phase] Phases A, B, C
AMPL [program output RMS/DC voltage] * 0–156 V or 0–312 V
(default: 0.00V)
CURL [program RMS/DC current limit] 0–13 A or 0–6.5 A (default: 5.00A
dependent on voltage range)
FREQ
[program output frequency] **
40–5000 Hz (default: 60 Hz)
θ ANG
[program phase angle offset] *** 0–360° (default: 0°, 120°, 240°
dependent on phase selected)
FUNC
[program output waveform] ****
Default: Sine