Operating instructions

SW 5250A•SW 3500A•SW 1750A Operation
Operation Manual 3-25
7   !0= %!
The SYSTEM COMM (Communications) sub-menu allows you to:
• Configure the GPIB address and display remote status.
• Display firmware version information.
USER
COMM
EXTERNAL
FAULTS
CONFIG
SYSTEM OUTPUT [OFF]

GPIB ADDR 25
ECDI VER X.XX
DWSB VER X.XX
TMB VER X.XX
BAUD RATE 57600
DWSB ON-LINE
T&MB ON-LINE
The DWSB and T&MB fields indicate the internal communication status of the Digital
Waveform Synthesis board and Test and Measurement board. These should always
indicate ON-LINE unless a failure has occurred (T&MB will indicate OFF-LINE if this
option is not present).
COMM Sub-Menu Status and Information Data:
Menu Item Status and Information Line Range/Default Value
GPIB ADDR [select gpib address] Range 1–30
ECDI VER X.XX
DWSB VER X.XX
TMB VER X.XX
[installed firmware version] —
BAUD RATE [RS-232 Baud Rate]
Range 300–57600
Default 57600
DWSB [Digital waveform status] On-Line/Off-Line
T&MB [Test & Measurement status] On-Line/Off-Line