Operating instructions

SW 5250A•SW 3500A•SW 1750A Operation
Operation Manual 3-41
- +'3%$!?'* $+%
This example illustrates programming the SW for a voltage dropout on a 120V sine
waveform that starts at 45° with a duration of 1 millisecond and an amplitude of 10
volts.
PROGRAM
MEASURE
WAVEFORM
SEQUENCE
INSTR
SYSTEM
MAIN MENU OUTPUT [OFF]
1. At the MAIN MENU, select the WAVEFORM menu, then press < Enter >.
LOAD
EDIT
VIEW
SAVE
DELETE
WAVEFORM OUTPUT [OFF]
2. The WAVEFORM Menu will default to the LOAD sub-menu. If the cursor is not
pointing to LOAD, use the Knob or Up/Down Arrow keys to select LOAD .
3. Press the Enter key to enter the FUNC (function) mode.
4. Press < Enter > again to place a box around the waveshape selection.
5. Use the Knob to cycle through the waveshape selections until SINE appears in
the FUNC box.