Operating instructions

Operation Manual 4-1
 




  
The following standard waveforms are provided in the SW Series:
  



D

Clip0 A sine wave with the positive halfcycle clipped at 0V from
50 to 130°
1.0 40-5000 Hz
ClipPos A sine wave with the positive halfcycle clipped from
50 to 130°
1.0 40-5000 Hz
ClipNeg A sine wave with the positive halfcycle set to a 50%
negative value from 50 to 130°
1.0 40-5000 Hz
DC+ Used to operate the SW as a positive DC source
(true rms)
0.7071 N/A
DC- Used to operate the SW as a negative DC source
(true rms)
0.7071 N/A
DcRip03+ +DC with 3% ripple. Frequency of the ripple is deter-
mined by the programmed output frequency (true rms)
0.7071 40-5000 Hz
DcRip03- -DC with 3% ripple. Frequency of the ripple is deter-
mined by the programmed output frequency (true rms)
0.7071 40-5000 Hz
DcRip10+ +DC with 10% ripple. Frequency of the ripple is deter-
mined by the programmed output frequency (true rms)
0.7071 40-5000 Hz
DcRip10- -DC with 10% ripple. Frequency of the ripple is deter-
mined by the programmed output frequency (true rms)
0.7071 40-5000 Hz
Drop45 Sine with a drop-out above 0V from 45 to 60° 1.0 40-5000 Hz
DropNeg Sine with a drop-out to -Vpeak from 4 to 50° 1.0 40-5000 Hz
DropPeak Sine wave with drop-out to 0V from 8 to 110° 1.0 40-5000 Hz
ExtrnDir DC for use with System External direct input 1.0 40-5000 Hz
FlatTp05 Flat-top sine wave with 5% distortion (true rms) 0.9344 40-5000 Hz
FlatTp10 Flat-top sine wave with 10% distortion (true rms) 0.8894 40-5000 Hz