Operating instructions
Standard Waveforms SW 5250A•SW 3500A•SW 1750A
4-2 Operation Manual
D
FlatTp15 Flat-top sine wave with 15% distortion (true rms) 0.8545 40-5000 Hz
FlatTp20 Flat-top sine wave with 20% distortion (true rms) 0.8251 40-5000 Hz
Four3 Fourier square wave with 1st and 3rd harmonics
(true rms)
0.8946 40-5000 Hz
Four5 Fourier square wave with 1st, 3rd, and 5th harmonics
(true rms)
0.8703 40-5000 Hz
Four7 Fourier square wave with 1st, 3rd, 5th, and 7th harmonics
(true rms)
0.8595 40-5000 Hz
Four9 Fourier square wave with 1st, 3rd, 5th, 7th, and 9th
harmonics (true rms)
0.8537 40-5000 Hz
FulRect+ Positive DC full rectified sine wave 1.0 40-5000 Hz
FulRect- Negative DC full rectified sine wave 1.0 40-5000 Hz
HalfCyc Sine wave with 90 to 180° at 0Volts 1.0 40-5000 Hz
HlfRect+ Positive DC half rectified sine wave 1.0 40-5000 Hz
HlfRect- Negative DC half rectified sine wave 1.0 40-5000 Hz
Inrush Sine wave with first quarter (0 to 90°) at 0Volts 1.0 40-5000 Hz
Noisz010 Sine with 10% noise at zero crossings (true rms) 1.0 40-5000 Hz
Noisz100 Sine with 100% noise at zero crossings (true rms) 1.0 40-5000 Hz
Pcntl110 Phase control at 110° 1.0 40-5000 Hz
Pcntl170 Phase control at 170° 1.0 40-5000 Hz
Scratch Waveform scratchpad. This is the waveform edit work
area. Waveforms being edited can be output for testing
purposes before they are saved to non-volatile memory.
1.0 Maximum of
waveform
loaded
SinDc01+ Sine wave with +1% DC offset 1.0 40-5000 Hz
SinDc01- Sine wave with - 1% DC offset 1.0 40-5000 Hz
SinDc10+ Sine wave with +10% DC offset 1.0 40-5000 Hz
SinDc10- Sine wave with - 10% DC offset 1.0 40-5000 Hz
SinDc20+ Sine wave with +20% DC offset 1.0 40-5000 Hz
SinDc20- Sine wave with - 20% DC offset 1.0 40-5000 Hz
SinDc50+ Sine wave with +50% DC offset 1.0 40-5000 Hz
SinDc50- Sine wave with - 50% DC offset 1.0 40-5000 Hz
Sine Sine wave (true rms) 1.0 40-5000 Hz
Spike200 Sine with spikes at peaks. Spikes are from 85 to 95°
and calibrated to be 200Vpeak when programmed to
120Vrms
1.1785 40-5000 Hz