Operating instructions

Installation / Initial Operation
-32-
Next set stepping
For the program mode, you can select the following for the next set stepping:
 without no next step setting activated
 quantity reached after expiration of the piece counter of the current set, the next set
will be loaded
 quantity, set 1 same as “quantity reached”, additionally set 1 will be loaded after
program end
Auxiliary functions (see 5.1.2 Display Elements)
 off
 on Auxiliary functions are activated.
Input field appears in the display and outputs can be assigned.
See also system -> I/O-configuration -> output functions and system -> system-times -> clamp
auxiliary function
Operating modes
This parameter determines which modes are possible
 single set
 single set+ manual
 single set+ program
 single set+ manual + program
Pin before parameter
This parameter determines if the service/parameter-level can be achieved with or without PIN entry.
 off can be looked at without Pin entry, but cannot be changed
 on parameters can only be read with the password “2505”.
(with “250565” they can also be changed”)
System equip
 off diverse parameters are turned off
 on
