Technical data
Table Of Contents
- General Information
- Safety
- 3. Transport and Storage
- Product Features
- Technical Data
- Configuration and Functions
- 6.1. Elements
- 6.2. Menu, sections and parameters
- Machine setting
- If the same analog measuring system which is used for the angle also used for the angle Cutting length, then it is necessary, set the values for the cutting length calculation.
- Setting values with minimum angle: Place the cursor in the first row and first column of the table (line: min; column: S. Beg). Now, enter the smallest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Min; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the minimum angle are set up.
- Setting values with maximum angle:
- Place the cursor in the second row and second column of the table (line: max; column: S. Beg). Now, enter the biggest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Max; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the maximum angle are set up.Configuration of inputs and outputs
- 7. Operation
- 8. Interferences
- Maintenance
- Type Designation
- Accessories
Product Features
- 10 -
4. Product Features
Essential features:
Analog or digital outputs for 1 - 3 speed operation
16 free programmable digital in-/outputs
Program memory (1000 sets)
Angle control / gap control / backgauge
Limitation of the cutting length
Material List for angle and gap control
The single axis controller of P40 series is applicable
to easy positioning tasks. An important feature is the
easy structured function menu. It allows a quick and
comfortable setting of the target value, if necessary
a specific quantity of desired pieces, an angle or the
gap. Target and actual value of the axes plus
quantity will be displayed on the front panel. The
keyboard is simple and user-friendly. With the inputs
the cutting angle or gap can be displayed and
controlled. These encoder inputs work in an analog
mode. A back stop can be programmed. The P40
series has an internal program memory with up to
1000 lines. For the positioning two different kinds of
output signals are available: Switch mode
positioning and PID-analog output. The P40 series
can alternatively be supplied with 24VDC or 24VAC.
An optional serial interface allows data transmission
for communication with a superior system.
Basic modes of operation:
The P40 consists of three general operation modes:
1. Manual: Inching operation moves the axes through operating the keypad or external switches.
2. Single: A whole set can be worked off.
3. Program: In this operation mode a programmed set can be worked off.