Technical data
Table Of Contents
- General Information
- Safety
- 3. Transport and Storage
- Product Features
- Technical Data
- Configuration and Functions
- 6.1. Elements
- 6.2. Menu, sections and parameters
- Machine setting
- If the same analog measuring system which is used for the angle also used for the angle Cutting length, then it is necessary, set the values for the cutting length calculation.
- Setting values with minimum angle: Place the cursor in the first row and first column of the table (line: min; column: S. Beg). Now, enter the smallest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Min; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the minimum angle are set up.
- Setting values with maximum angle:
- Place the cursor in the second row and second column of the table (line: max; column: S. Beg). Now, enter the biggest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Max; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the maximum angle are set up.Configuration of inputs and outputs
- 7. Operation
- 8. Interferences
- Maintenance
- Type Designation
- Accessories
Technical Data
- 11 -
5. Technical Data
P40 – ELGO-position controller
Input supply voltage 24 VDC
Power input 24 VDC; max. 150 mA (no-load condition)
Rotary encoder supply unit 24 VDC or 5VDC ; max. 130 mA
Analog input (option) 12 Bit resolution ; 3,3 V Supply measuring system
Input signals The Pin assignment of the inputs and the input logic are programmable
Minimum pulse duration: 300 ms
Input current /Pin: max. 10 mA
Output signals The Pin assignment of the outputs and the output logic are programmable
Open Emitter (PNP)
Complete short-circuit-proof
Output current: max. 80 mA
Recovery diode is integrated
Actual value memory E² Prom
Durability: 10
5
On-Off-Switch-Cycle or 10 years
Connection technology Phoenix Connectors
Displays LCD Dot-Matrix 128 x 80 mm with white backlight
Hardware 32-Bit-Microprocessor with 1 MByte Flash 56 Kbyte RAM
System accuracy +/ -1 Increment
Input frequency
15 KHz (upgrade on enquiry possible) equals by 0,1 mm resolution: 120
m/min. (2 m/s)
Housing dimensions W x H x D = 144 mm x 144 mm x 40 mm (without connector)
Disruption degree W x H = 136 mm x 136 mm
Installation depth without
connector
40 mm
Installation depth with
connector
75 mm
Ambient temperature 0 to +45 °C