Technical data
Table Of Contents
- General Information
- Safety
- 3. Transport and Storage
- Product Features
- Technical Data
- Configuration and Functions
- 6.1. Elements
- 6.2. Menu, sections and parameters
- Machine setting
- If the same analog measuring system which is used for the angle also used for the angle Cutting length, then it is necessary, set the values for the cutting length calculation.
- Setting values with minimum angle: Place the cursor in the first row and first column of the table (line: min; column: S. Beg). Now, enter the smallest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Min; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the minimum angle are set up.
- Setting values with maximum angle:
- Place the cursor in the second row and second column of the table (line: max; column: S. Beg). Now, enter the biggest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Max; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the maximum angle are set up.Configuration of inputs and outputs
- 7. Operation
- 8. Interferences
- Maintenance
- Type Designation
- Accessories
Configuration and Functions
-20-
Software-end position MIN/MAX
These two values can be used if no mechanical limit switches are present or additionally for already
existing mechanical limit switches.
End position min.: This value should be between the smallest length/position that hast o be worked
off and zero (and shortly before the mechanical limit switch respectively).
End position max.: This value should be between the largest length/position that has to be worked
off and the maximum length (and shortly before the mechanical limit switch respectively). If one of
these two values is reached, the positioning procedure is interrupted.
Factor
A factor (0.00001 to 9.9999) can be entered in this Register. The incoming pulses will be multiplied
by this factor, to manipulate the display to required dimensions. If no multiplication is required, this
Register must be set to 1.00000.
Example: rotary encoder = 1000
[RPM]
]pulses[
Spindle distance = 100
[
]
[]
RPM
mm
]pulse[
]mm[
1,0
]pulses[1000
]mm[100
pulses
]mm[distance Spindle
Factor ===
Blade length
Here, the maximum blade length can be entered (in mm). With this the maximum input length of the
cutting length in single mode and program mode will be defined. If no blade length (parameter
value = 0) will be defined, the cutting length in single or program mode will be percentage
calculated.