Technical data
Table Of Contents
- General Information
- Safety
- 3. Transport and Storage
- Product Features
- Technical Data
- Configuration and Functions
- 6.1. Elements
- 6.2. Menu, sections and parameters
- Machine setting
- If the same analog measuring system which is used for the angle also used for the angle Cutting length, then it is necessary, set the values for the cutting length calculation.
- Setting values with minimum angle: Place the cursor in the first row and first column of the table (line: min; column: S. Beg). Now, enter the smallest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Min; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the minimum angle are set up.
- Setting values with maximum angle:
- Place the cursor in the second row and second column of the table (line: max; column: S. Beg). Now, enter the biggest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Max; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the maximum angle are set up.Configuration of inputs and outputs
- 7. Operation
- 8. Interferences
- Maintenance
- Type Designation
- Accessories
Configuration and Functions
-22-
Parameter of time
Position reached
The signal is based on a variable time during input of a time value or statically/maintained (axis in
position) if the value is set to 0.
The appropriate output signal becomes active if:
Actual value = demand value +/– stop offset
By reached position the signal is switched to pulsed if a value (0.1 … 99.9 sec) is entered into the
register „position reached“.
Spindle compensation
In the peak of the loop drive, the drive signals drop-out. The controller returns to the target value
when the parameterized time expires (adjustment range 0.1 sec - to 99.9 sec).
Velocity change manual mode
Here the time in hand can be entered to set the speed from the low speed to the next higher speed.
System monitoring
For encoder monitoring a time can be entered (0.1... 99.9 seconds). If for the entered time no more
pulses are detected at the controller in order to stop the engine, the operating signals are switched
off.
Fall-delay time controller enables
After the start command the output "closed loop inhibit” is activated. After reaching the intended
position and only after the operational sequence (0.1 … 99.9 sec) in register “time delay for drive
inhibit” is worked off the output is set back.
Start delay time
With an initial instruction the start of the positioning is delayed for the entered time.
Shutdown Position Control
Here the time in 0.1 sec. can be entered for shutdown after the position is reached.
Retract
Here the time in 0.1 sec. can be entered for return from the peak of the retract to the target value.
Reversal Reference drive
In the peak of the reference run, the drive signals drop-out. The controller will continue positioning
when this time expires (adjustment range 0.1 sec - to 99.9 sec).