Technical data
Table Of Contents
- General Information
- Safety
- 3. Transport and Storage
- Product Features
- Technical Data
- Configuration and Functions
- 6.1. Elements
- 6.2. Menu, sections and parameters
- Machine setting
- If the same analog measuring system which is used for the angle also used for the angle Cutting length, then it is necessary, set the values for the cutting length calculation.
- Setting values with minimum angle: Place the cursor in the first row and first column of the table (line: min; column: S. Beg). Now, enter the smallest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Min; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the minimum angle are set up.
- Setting values with maximum angle:
- Place the cursor in the second row and second column of the table (line: max; column: S. Beg). Now, enter the biggest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Max; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the maximum angle are set up.Configuration of inputs and outputs
- 7. Operation
- 8. Interferences
- Maintenance
- Type Designation
- Accessories
Configuration and Functions
-27-
6.2.4.1. System parameters
Positioning measurement system
The type of measurement system is defined in this parameter.
Axis deactivated
Microcontroller
PID Controller
Analog potentiometer
Direction change manual
The allocation of the direction for the corresponding keys can be set as inverted in this parameter.
normal
inverted
Drive signals
With configuration of the motor signals different starting combinations for the different speeds can
be set.
Drive signals = Mode 1
3 speeds (ELGO-standard)
Speed = output signals 1-3 ascending
Output 4 sets direction reverse
Output signals 1 2 3 4
Creep speed forward X
Slow speed forward X X
Fast speed forward X X X
Creep speed backward X X
Slow speed backward X X X
Fast speed backward X X X X
Drive signals = Mode 2
2 speeds
Independent outputs forwards and reverse (additional information BCD-Code: cca553)
Independent outputs fast and slow
Output signals 1 2 3 4
Creep speed forward X X
Slow speed forward
Fast speed forward X X
Creep speed backward X X
Slow speed backward
Fast speed backward X X