Technical data
Table Of Contents
- General Information
- Safety
- 3. Transport and Storage
- Product Features
- Technical Data
- Configuration and Functions
- 6.1. Elements
- 6.2. Menu, sections and parameters
- Machine setting
- If the same analog measuring system which is used for the angle also used for the angle Cutting length, then it is necessary, set the values for the cutting length calculation.
- Setting values with minimum angle: Place the cursor in the first row and first column of the table (line: min; column: S. Beg). Now, enter the smallest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Min; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the minimum angle are set up.
- Setting values with maximum angle:
- Place the cursor in the second row and second column of the table (line: max; column: S. Beg). Now, enter the biggest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Max; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the maximum angle are set up.Configuration of inputs and outputs
- 7. Operation
- 8. Interferences
- Maintenance
- Type Designation
- Accessories
Contents
- 3 -
7. Operation ....................................................................................................................... 36
7.1 Operation Modes .............................................................................................................. 36
7.1.1 Manual mode .................................................................................................................... 36
7.1.2 Single mode ....................................................................................................................... 36
7.1.3 Program mode ................................................................................................................... 36
7.1.3.1 Input of a program .......................................................................................................... 36
7.1.3.2. Handle of a program .................................................................................................. 37
7.1.4 Reference....................................................................................................................... 37
7.1.4.1 Function of reference drive ........................................................................................... 37
7.2 Connector pin assignment .................................................................................. 38
7.2.1 Overview Terminal Assignment ...................................................................................... 39
7.3 Diagnostics ....................................................................................................................... 40
8. Interferences .................................................................................................................. 41
8.1 Security .............................................................................................................. 41
8.2 Electrical interference suppression ....................................................................... 42
8.3 Restart after fault clearance ................................................................................ 42
8.4 EMC information ................................................................................................ 43
9 Maintenance ................................................................................................................. 44
10 Type Designation ......................................................................................................... 45
11 Accessories .................................................................................................................... 46