Technical data
Table Of Contents
- General Information
- Safety
- 3. Transport and Storage
- Product Features
- Technical Data
- Configuration and Functions
- 6.1. Elements
- 6.2. Menu, sections and parameters
- Machine setting
- If the same analog measuring system which is used for the angle also used for the angle Cutting length, then it is necessary, set the values for the cutting length calculation.
- Setting values with minimum angle: Place the cursor in the first row and first column of the table (line: min; column: S. Beg). Now, enter the smallest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Min; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the minimum angle are set up.
- Setting values with maximum angle:
- Place the cursor in the second row and second column of the table (line: max; column: S. Beg). Now, enter the biggest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Max; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the maximum angle are set up.Configuration of inputs and outputs
- 7. Operation
- 8. Interferences
- Maintenance
- Type Designation
- Accessories
Configuration and Functions
-31-
6.2.5 Material Table
In this table the material specific experienced values for cut angle and gut gap can be entered in this
parameter. The more inputs are made the more precise the non-existing values in the table can be
calculated through interpolation. By operating one set or more sets the only values that have to be entered
are the kind of material (material no.) and the metal sheet thickness.
The buttons F1 and F3 are used to scroll through the material table. The button F2 is used for switching with
the cursor from one column to another column. The values have to be higher than zero in both columns.
If the value is zero the relevant line will be detected as the end of the material table. As a result of this all
subsequent values won’t be recalled.
Advert!
Thevalueshavetobehigherthanzeroinbothcolumns.
6.2.5.1 Explanation of the Interpolation
Because of that it is possible to deposit only values in 1mm sequences, the values between this sequences
will be interpolated. The calculation of the intermediate steps take as a basis of two sequenced material
thicknesses for the action of the values of gap and angle.
Example: The red marked values are firmly rooted in the material table. Now a value for the material
thickness of 2.5 mm will be loaded. For the clarity in this example, only the calculation of the value of the
gap is illustrated. The calculation of the intermediate steps for the angle according to the same principle.
Thickness Gap
A
ngle
1 0.10 0.75
2 0.20 1.00
3 0.30 1.25
4 0.40 1.50
5 0.50 1.75
… … …
1.0 2.0 3.0 4.0 5.0
0.1
0.2
0.3
0.4
0.5
Mat.-Stärke
[mm]
Spalt
Ga
p
Material thickness in mm