Technical data
Table Of Contents
- General Information
- Safety
- 3. Transport and Storage
- Product Features
- Technical Data
- Configuration and Functions
- 6.1. Elements
- 6.2. Menu, sections and parameters
- Machine setting
- If the same analog measuring system which is used for the angle also used for the angle Cutting length, then it is necessary, set the values for the cutting length calculation.
- Setting values with minimum angle: Place the cursor in the first row and first column of the table (line: min; column: S. Beg). Now, enter the smallest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Min; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the minimum angle are set up.
- Setting values with maximum angle:
- Place the cursor in the second row and second column of the table (line: max; column: S. Beg). Now, enter the biggest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Max; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the maximum angle are set up.Configuration of inputs and outputs
- 7. Operation
- 8. Interferences
- Maintenance
- Type Designation
- Accessories
Configuration and Functions
-33-
Language
German
English
Axes active
Backgauge + Gap + Angle
Backgauge + Gap
Backgauge + Angle
Backgauge
Mode pieces counter single block
The mode pieces counter for the single mode can be defined here.
Without counter
Automatically subtracting
Automatically adding
Mode pieces counter program
The mode counter fort he program mode can be defined in this parameter.
automatically subtracting
automatically adding
Block size
1
5
10
20
25
50
75
100
Block shift
Auto start after changing a set is defined in this parameter.
Not active
After set without start
After set with start
Time Block shift
The time frame from the end of a set to the start oft he new set is defined in this parameter.
1/2/3/4/5 sec.
Cutting length
not active
active