Technical data

Operation
-39-
7.2.1 Overview Terminal Assignment
ST1 Encoder Backgauge ST2 Encoder Gap and Angle
1 GND1 GND
2 5VDC/24VDC2 3,3VDCSupply
3 A‐Channel3 AnalogInputGap0..3,3VDC
4 B‐Channel4
5 Earth5 Earth
6 /A‐Channel6
7 /B‐Channel7
8 Z‐Channel(Indexpulse)8
9 /Z‐Channel(Indexpulse)9 AnalogInputAngle0..3,3VDC
  
ST3Inputs  ST4Inputs
1 GND1 GND
2 24VDC(Output)2 24VDC(Output)
3 LimitSwitchMin.Axis13 StopPositioning
4 LimitSwitchMin.Axis24 StartPositioning
5 LimitSwitchMin.Axis35 RetractAxis1
6 LimitSwitchMax.Axis16 ReferenceAxis1
7 LimitSwitchMax.Axis27 Counter(add./subtr.)
8 LimitSwitchMax.Axis38
9  9
10  10
  
ST5Outputs  ST6Outputs
1 GND1 GND
2 +24VDC(Output)2 24VDC(Output)
3 DriveSignal1Axis13 ControllerEnableAxis1
4 DriveSignal2Axis14 ReferenceDriveRunAxis1
5 DriveSignal3Axis15 Quantityreached
6 DriveSignal4Axis16 CuttingEnable
7 DriveSignal1Axis27 CuttingLengthreached
8 DriveSignal2Axis28
9 DriveSignal1Axis39
10 DriveSignal2Axis310
  
ST7AnalogOutput(PID)  ST9Supply
1 GND1 GND
2 Analog‐targetValue+/‐10VDC2 24VDC
3 Earth3 Earth
  
MCC1AnalogOutput/MotorControllerMCC  P1PC‐Interface
1 ControllerEnable1 GND
2  2 RS232RX
3 A‐Channel3 RS232TX
4 B‐Channel4 CANL(Option)
5 /A‐Channel5 CANH(Option)
6 /B‐Channel6 MD0(Special)
7 Analog‐targetValue+/‐10VDC7 MD1(Special)
8 GND8 MD2(Special)