Technical data
Table Of Contents
- General Information
- Safety
- 3. Transport and Storage
- Product Features
- Technical Data
- Configuration and Functions
- 6.1. Elements
- 6.2. Menu, sections and parameters
- Machine setting
- If the same analog measuring system which is used for the angle also used for the angle Cutting length, then it is necessary, set the values for the cutting length calculation.
- Setting values with minimum angle: Place the cursor in the first row and first column of the table (line: min; column: S. Beg). Now, enter the smallest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Min; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the minimum angle are set up.
- Setting values with maximum angle:
- Place the cursor in the second row and second column of the table (line: max; column: S. Beg). Now, enter the biggest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Max; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the maximum angle are set up.Configuration of inputs and outputs
- 7. Operation
- 8. Interferences
- Maintenance
- Type Designation
- Accessories
- 4 -
1. General Information
1.1. Information Operation Manual
The manual contains important information regarding the handling of the controller.
Precondition for safe operation is the compliance with the specified safety and handling instructions.
Moreover, observe the existing local accident prevention regulation and general safety rules.
Please read the operation manual carefully before starting to work. The manual should be kept accessible at
anytime. The illustrations in the manual are for better representation of the facts they are not necessarily to
scale and can be slightly different to the actual construction.
1.2. Explanation of Symbols
Warning notices
Warning notices are characterized by symbols in the operation manual.
The notes will be introduced by signal words to express the magnitude of the danger.
Follow these advices in order to avoid accidents and injuries to persons and property.
DANGER!
... adverts to direct dangerous situations that can lead to death or severe injuries.
CAUTION!
... advices to potentially dangerous situations that can lead to death or severe
injuries.
ATTANTION!
... advices to potentially dangerous situations that can lead to damages on
property.
General Information