Technical data
Table Of Contents
- General Information
- Safety
- 3. Transport and Storage
- Product Features
- Technical Data
- Configuration and Functions
- 6.1. Elements
- 6.2. Menu, sections and parameters
- Machine setting
- If the same analog measuring system which is used for the angle also used for the angle Cutting length, then it is necessary, set the values for the cutting length calculation.
- Setting values with minimum angle: Place the cursor in the first row and first column of the table (line: min; column: S. Beg). Now, enter the smallest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Min; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the minimum angle are set up.
- Setting values with maximum angle:
- Place the cursor in the second row and second column of the table (line: max; column: S. Beg). Now, enter the biggest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Max; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the maximum angle are set up.Configuration of inputs and outputs
- 7. Operation
- 8. Interferences
- Maintenance
- Type Designation
- Accessories
General Information
- 6 -
1.4. Demounting and Disposal
Unless otherwise authorized, dispose the item considering the safety instructions.
Before demounting
Disconnect the power supply
Secure against re-start
Disconnect supply lines physically and discharge remaining energy
Dispose operating supplies with respect to the environment
Disposal
Recycle the decomposed elements:
Scrap metal elements
Recycle plastic parts
Dispose the rest of the components according to their material consistence
ATTENTION!
Wrong disposal Î damage caused to the environment!
Electronic waste, electronic components, lubricants and operating supplies are
liable to treatment of hazardous waste.
Only approved specialized companies should perform disposal.
Local authorities and waste management facilities provide information about environmentally suitable
disposal.