Technical data
Table Of Contents
- General Information
- Safety
- 3. Transport and Storage
- Product Features
- Technical Data
- Configuration and Functions
- 6.1. Elements
- 6.2. Menu, sections and parameters
- Machine setting
- If the same analog measuring system which is used for the angle also used for the angle Cutting length, then it is necessary, set the values for the cutting length calculation.
- Setting values with minimum angle: Place the cursor in the first row and first column of the table (line: min; column: S. Beg). Now, enter the smallest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Min; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the minimum angle are set up.
- Setting values with maximum angle:
- Place the cursor in the second row and second column of the table (line: max; column: S. Beg). Now, enter the biggest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Max; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the maximum angle are set up.Configuration of inputs and outputs
- 7. Operation
- 8. Interferences
- Maintenance
- Type Designation
- Accessories
- 7 -
2. Safety
2.1. General Cause of Risks
This chapter gives an overview about all important safety aspects to guarantee an optimal protection of
employees.
Non-observance of the instructions mentioned in this operation manual can result in hazardous situations.
2.2. Personal Protective Equipment
Employees should wear protective clothing during installation of the device to minimize the risk of accidents.
Therefore:
Change into protective clothing before beginning the work process. Also observe any labels in the operating
area regarding protective clothing.
Protective clothing
Safety working clothing
... is close-fitting
... is tear proof
... has tight sleeves without distant parts
Also wear no rings, necklaces or other jeweler.
Protective gloves
... for protecting the hands against abrasion and cuts
Safety