Technical data
Table Of Contents
- General Information
- Safety
- 3. Transport and Storage
- Product Features
- Technical Data
- Configuration and Functions
- 6.1. Elements
- 6.2. Menu, sections and parameters
- Machine setting
- If the same analog measuring system which is used for the angle also used for the angle Cutting length, then it is necessary, set the values for the cutting length calculation.
- Setting values with minimum angle: Place the cursor in the first row and first column of the table (line: min; column: S. Beg). Now, enter the smallest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Min; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the minimum angle are set up.
- Setting values with maximum angle:
- Place the cursor in the second row and second column of the table (line: max; column: S. Beg). Now, enter the biggest possible cut angle. Let down the cutting blade to beginning of the cut (till the point, where the upper beam and lower beam of the scissors just touch) and press the F2 key. Now place the cursor on the field in the first row and second column (row: Max; column: S. End) and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the maximum angle are set up.Configuration of inputs and outputs
- 7. Operation
- 8. Interferences
- Maintenance
- Type Designation
- Accessories
Conventional use, Transport, Storage
- 8 -
2.3. Conventional Use
The controller P40 is for the limited purpose as described in this manual:
The controller P40 is constructed for positioning uses only.
CAUTION!
Danger through non-conventional use!
Non-intended use and non-observance of this operation manual can lead to dangerous
situations.
Therefore:
Use P40 only as described
Strictly follow this manual
Avoid in particular:
Remodeling, refitting or changing of the device or parts of it with the intention to alter
functionality or scope of the position controller.
ELGO is not liable for any damages resulting from improper use of the product.
3. Transport and Storage
3.1. Safety Instructions for Transport/Unpacking and Loading
ATTENTION!
Professional transport only.
Do not throw, hit or fold the package.
3.2. Handling of Packaging Material
Adverts for proper disposal refer to 1.4.