Installation Guide
8
Complete Installation
NOTE: To make easier the hood mounting on the cabinet, is
recomended to uninstall the blower motor located inside the
hood insert.
To uninstall the single or dual Blower motor
Remove the 6 x 16 mm bolts and the lock washers.
Press the spring clip (A) to release the blower mounting
plate right ange (B).
Slide the mounting plate to the right to release it, and put
it aside.
Install the range hood into the hood cabinet
Determine and make all necessary cuts in the wall or
roof for the vent system. Install the vent system before
installing the cabinet hood insert. See the “Venting
Requirements” section.
Determine the location where the power supply cable will
be run through the wall.
Drill a 1¼” (3.2 cm) hole at this location.
Pull enough power supply cable through the wall to allow
for easy connection to the terminal box.
Remove terminal box cover and set aside.
Remove knockout from the top of the vent hood and
install a UL listed or CSA approved ½” (1.3 cm) strain
relief.
Place the hood insert near its mounting position
and run the power supply cable through the strain relief
into terminal box (enough to make connection).
Tighten the strain relief screws.
Using 2 or more people, lift the hood insert into
hood cabinet.
1.
2.
3.
1.
2.
3.
4.
5.
6.
7.
8.
9.
A
B
B
A. Spring clip
B. Motor mounting plate
B
A
Fasten the hood insert using four 5 x 45 mm
screws to the hood cabinet and tighten securely.
Excessive weight hazard
Use two or more people to move and install hood insert.
Failure to do so can result in back or other injury.
To install the single or dual Blower motor
To install blower motor assembly, slide the left mounting
plate ange under the motor mounting bracket.
Push the right end of the motor mounting plate down
and snap it into the spring tab.
NOTE: The spring tab should be outside the slot
in the mounting plate.
Align mounting holes and install 6 x 16 mm bolts and 6.4
mm lock washers.
Attach power cord connector from the hood insert to
connector on wiring box.
10.
1.
2.
3.
4.
Upper Hood
Insert Motor Housings
4 mounting
screws
A. Bolt with lock washer
B. Mounting hole
A
B
A.Motor mounting bracket
B.Mounting plate left ange
B
A
A
B
A. Motor mounting plate
B. Spring clip
A. Bolt with lock washer
B. Mounting hole
A
B