Installation Guide

6
LIST OF MATERIALS
Removing the packaging.
I CAUTION
Remove carton carefully, wear gloves to protect against sharp edges.
I WARNING
Remove the protective film covering the product before putting into operation.
Supplied Part Pieces Supplied Part Pieces
Hood assembly and
LED lamps already installed
1
10” round air transition
1
6x80 mm
4
Ø 6.4x11 mm washers
5
6x16 mm
5
Ø 5.3x20 mm washers
2
3.5x9.5 mm
4
10x50 mm wall anchors
2
4.2x19 mm
6
Drip tray bracket
30”, 36”, 42”: 1
48”: 2
Drip tray screws
4
Drip tray
30”, 36”, 42”: 2
48”: 3
Torx 20 adapter
1
Parts no supplied
Tools/Materials required
• Level
• Drill with 1
1
⁄4” (3.0 cm),
1
⁄8” (3.0 mm),
1
⁄16” (4.8 mm) drill bits
• Pencil
• Wire stripper or utility knife
• Tape measure or ruler
• Pliers
• Caulking gun and weatherproof caulking compound
• Vent clamps
• Saber or keyhole saw
• Metal snips
• Screwdrivers:
- Phillips
- Flat-blade
Parts needed
• Home power supply cable
• 1 - ½” (12.7 mm) UL listed or CSA approved strain relief
• 3 UL listed wire connectors
• 1 wall or roof cap
• Metal vent system