Instruction Manual

6
CAUTION: FOR GAS RANGES INSTALLATION: MOUNT
THIS HOOD SO THAT THE BOTTOM EDGE IS AT 30" (76,2
CM) ABOVE THE COOKING SURFACE.
FOR ELECTRIC RANGES INSTALLATION: MOUNT THIS
HOOD SO THAT THE BOTTOM EDGE IS NOT LESS THAN
30" (76,2 CM) ABOVE THE COOKING SURFACE.
HOUSEHOLD USE. PLEASE, READ INSTALLATION
MANUAL FOR SPECIFIC APPLICATION.
If the instructions for installation for the gas hob specify a
greater distance, this must be adhered to.
Check your ceiling height and the hood height maximum
before you select your hood.
Consult last pages of this manual for installation
instruction and electrical connection steps.
Operation
ON/OFF light button
Press to turn the cooktop light on or off.
"BOOST" speed selection key
1st push: to activate the intensive suction
speed “BOOST”, timed for 7 minutes
Note: after 7 minutes, the hood will return
to the previously set suction speed
2nd push ("BOOST" activated): to exit
the function and return to the speed
previously set.
Note: the speed key previously set
remains lit during BOOST operation.
Speed selection key 3
Push to activate the high speed (suction
power)
Speed selection key 2
Push to activate the average speed
(suction power)
Speed selection key 1
Push to enable the low speed (suction
power)
Power button
Push to switch on the hood and enable
speed selection;
if pushed while the motor is running, the
latter will stop
Note: if no function is activated within 10
seconds, the hood turns off.
Filter Saturation indicator lights
The hood signals at regular intervals that the filters must be
serviced.
Keys and lit and flashing very slowly:
service the grease filter.
Keys and lit and flashing quickly:
service the odour filter.
Note: The filter saturation warning signal is visible within
the first 10 seconds after the hood is switched on.
Reset filter saturation indicator:
Press and hold the keys and
The keys will flash quickly to confirm that reset has been
completed
Activation of filter saturation indicators
Note: this operation must be performed with the hood off.
- Grease filter
Push and hold down the keys and to
activate the function
the keys light up flashing very slowly, indicating that the
grease filter indicator can be activated
Note: Push the keys and to activate or
deactivate
- Odour filter
Push and hold down the keys and to
activate the function
the keys light up flashing quickly, indicating that the
odour filter indicator can be activated (normally deactivated)
Note: Push the keys and to activate or
deactivate