Use and Care Guide

• If not already done, install 1/2” conduit connector in j-

box.

Mounting the duct cover

• Position the duct cover over the mounted hood.

• Slide the bottom of the duct into the canopy area.

• Position the top of the duct over the duct mounting

bracket. If a telescopic duct cover is used, grab the

upper part of the telescopic duct cover, pull it and place

it in the duct cover mounting bracket.

• Secure the top of the duct with 2 assembly screws

provided.

• Secure the bottom of the duct with 2 assembly screws

provided.

Install the charcoal filter on the back side of the grease filter,

install both on the range hood and turn power on at service

panel. Check operation of the hood.

If range hood does not operate:

• Check that the circuit breaker is not tripped or the house

fuse blown.

• Disconnect power supply. Check that wiring is correct.

• Check that the internal General ON/OFF Push button

Switch is switched ON.