Use and Care Guide

Charcoal filter inclusion and exclusion (Recirculating

accessories)

• The charcoal filter inclusion or exclusion can be set by

pressing the “+” and “-” buttons at the same time for 5

seconds.

• The Inclusion or exclusion of charcoal filter must be

selected while the lamps and the motor are OFF.

• When the charcoal filter has been excluded, the charcoal

filter alarm is disabled.

Heat sensor

• The control is equipped with a heat sensor that will turn

on the blower at third speed if excessive heat occurs

(over 149° F or 65°C) surrounding the control area.

• If the blower is OFF or if it is operating at first speed, the

blower will be set automatically to third speed, the

display shows the word "CArE" to indicate that heat

sensor has detected an excessive heat.

• During this state, the user may raise the blower speed to

fourth speed but can not decrease the speed.

• When the temperature level on the hood drops to

normal, the blower will operate in the setting defined by

the user before the alarm occured.