Installation guide

6
Speed 2 (medium aspiration): 15 minutes
Speed 3 (high aspiration): 10 minutes
Control panel with 7 buttons
To select the functions of the hood you simply touch the
controls.
Automatic operation (sensor) and
connection with SNAP
®
and Elica hob
(See related section)
Button ON/OFF lighting
Press briefly to switch on or off the lighting of
the hob. Press and hold to switch on or off
the room lighting (only on certain models).
Button for intensive speed (suction power)
selection – it lasts 5 minutes then it returns
to medium speed (suction power) or it
switches off if the delayed shutdown of the
hood is activated (only with remote control).
The button flashes in both cases to indicate
speed timing.
Button for high speed (suction power)
selection.
The button flashes if the delayed shutdown
of the hood is activated (only with remote
control).
Button for medium speed (suction power)
selection
The button flashes if the delayed shutdown
of the hood is activated (only with remote
control).
Button for low speed (suction power)
selection – when flashing, it indicates that
you must wash the grease filter.
The button flashes if the delayed shutdown
of the hood is activated (only with remote
control).
Button OFF motor (stand by)
Indicators of Filter Saturation
At regular time intervals, the hood signals the need to perform
filter maintenance.
Button
on with steady light: perform grease filter
maintenance.
Button
flashing: perform activated charcoal filter
maintenance.
Note: Filter saturation signal is visible within the first
minute after switching off the hood; within this time, the
reset of saturation indicators must be performed.
Reset of filter saturation indicators:
Press and hold the button
Activation of saturation indicator activated charcoal
filter
Note: this operation must be performed with the hood off.
This indicator is normally deactivated; press and hold the
button
to activate the function: the button lights
up with steady light.
To deactivate the function, press and hold the button
: the button lights up flashing.
Automatic operation (sensor), connection with SNAP
®
and Elica hob
Attention! The proper operation of the hood will depend on
the ’Setting of parameters for Automatic Operation’ (see
dedicated section)
Note: Automatic operation with the hob is only possible with
specific hobs. For further details, please contact the official
dealer or authorised technical assistance centre.
Automatic operation (sensor)
Press the button
.(the central LED lights up
in white).
The hood will switch on at the most suitable speed based on
the cooking fumes detected by the sensor on the hood.
Automatic operation of the hood with SNAP
®
Press the button .(the LEDs light up in
orange) to indicate that the hood can operate automatically
with the SNAP
®
Note: SNAP
®
is an auxiliary suction unit that can operate
together with the hood. For further information, please consult
the manual supplied with SNAP
®
Automatic operation of the hood with the Elica hob
Operation of the hood will also depend on use of the Elica
hob.
Press the button
.(the LEDs light up in white)
to indicate that the hood can automatically operate with the
Elica hob; thus, hood operation will also depend on use of the
Elica hob.