Installation guide

7
Note: Automatic operation with the hob is possible only with
specific cooking hobs; for further details, please contact the
authorised dealer or technical assistance centre.
Automatic operation of the hood with SNAP
®
and Elica
hob
Press the button
.(the LEDs light up in
orange) to indicate that the hood can operate automatically
with the hob and the SNAP
®
Setting of parameters for Automatic Operation
Note: All calibration, selection, setting and logical
connection operations described below can be performed
with the hood off (OFF).
The adjustment of parameters is regularly done
automatically every time the hood is reconnected to the
mains (e.g. with the first installation or after a blackout) or
manually.
Manual setting
To be performed when you notice unsatisfactory
functioning of the Automatic operation, and is done when
normal environmental conditions persist in the kitchen.
Manual setting includes:
• Hood calibration
• Selection of hob (gas, induction, or electric)
• Logical connection between the hood and the hob (if
you have an Elica hob).
• Logical connection between the hood and SNAP
®
(if
you have SNAP
®
).
Hood calibration
Press and hold the button
, all button LEDs
flash to indicate initiation of calibration; the process
will last for approximately 5 minutes.
Selection of the hob (gas , induction, or electric)
Press and hold simultaneously the buttons
and
: buttons , and
start flashing for 5 seconds.
Within this timeframe, press:
button
in case of gas hob
button
in case of electric hob
button
in case of induction hob
The preselected button remains lit to indicate the
selection was performed, after 10 seconds the
button flashes briefly to indicate that the performed
selection was recorded.
Logical connection between the hood and the hob (if
you have an Elica hob).
a. Simultaneously connect the hood and Elica hob.
b. the hood emits 2 acoustic signals (beeps) to
indicate that it can receive the connection signal
from the Elica hob.
c. the connection attempts with the Elica hob last for
5 minutes; within this time, the hood emits 3
consecutive acoustic signals (beeps) to indicate the
successful connection with the Elica hob.
d. Check the successful connection with the Elica
hob: Press the button
.(the LEDs
light up in white).
In case the logical connection between the hood
and Elica hob is not successful, proceed as
indicated below:
Disconnect and reconnect the hood from/to the
mains at least 5 times within 30 seconds.
Repeat the operations a-b-c-d described above
Logical connection between the hood and SNAP
®
(if
you possess a SNAP
®
).
Connection between the hood and SNAP
®
is
automatic. No other setting has to be performed.
User Servicing and Maintenance Instructions
Cleaning
Clean using ONLY the cloth dampened with neutral liquid
detergent. DO NOT CLEAN WITH TOOLS OR
INSTRUMENTS. Do not use abrasive products. DO NOT USE
ALCOHOL!
Steam screen
The steam screen must always be left closed and
opened only for maintenance (e.g. cleaning or changing
filters).
Fig. 12-15
Grease filter
Fig. 11-25
Traps cooking grease particles.
This must be cleaned once a month (or when the filter
saturation indication system – if envisaged on the model in
possession – indicates this necessity) using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolor
slightly, but this does not affect its filtering capacity.
Charcoal filter (filter version only)
Fig. 24
It absorbs unpleasant odors caused by cooking.
The charcoal filter can be washed once every two months (or
when the filter saturation indication system – if envisaged on
the model in possession – indicates this necessity) using hot